Work plan

2019
A.4.1 Mechanical and tribological characterization of DLC coatings obtained in industrial conditions
A.4.2 Post mortem analysis of samples deposited in industrial conditions
A.4.3 Protection of intellectual property rights
A.4.4 Support activities
A.4.5 Disemination

2018
A.3.1 Optimization of interlayer for DLC coatings
A.3.2 Stress evaluation for DLC coatings obtained in reactive HiPIMS processes
A.3.3 Detailed structural analysis of DLC coatings
A.3.4 Mechanical and tribological characterization of DLC coatings obtained in industrial conditions on planar flat samples
A.3.5 Detailed tribological analysis of DLC coatings on planar samples
A.3.6 Post mortem analysis of test samples
A.3.7 Update of the exploitation and dissemination plan
A.3.8 Support activities
A.3.9 Dissemination of results

 

2017
A.2.1 Characterization of reactive Ne-HiPIMS process
A.2.2 Implementation and testing of synchronized bias system
A.2.3 DLC thin film deposition in Ne-HIPIMS process
A.2.4 DLC thin film deposition in reactive Ne-HiPIMS process
A.2.5 Development of Interlayer for increased adhesion of DLC thin films
A.2.6 Preliminary structural analysis of DLC thin films
A.2.7 Mechanical and tribological characterization of DLC thin films obtained under laboratory conditions
A.2.8 Update of the exploitation and dissemination plan
A.2.9 Support activities
A.2.10 Dissemination of results

2016
A.1.1 Control of ionization degree and ion flux in the Ne-HiPIMS process
A.1.2 Characterization of Ne-HIPIMS process (spatial and temporal)
A.1.3 Defining of exploitation and dissemination plan
A.1.4 Support activities
A.1.5 Dissemination